mercuryleaf7
GLP-1 Novice
Would someone be able to help me/explain what's going on here?
So I got some V1 pens and I decided to test the accuracy where you stick an insulin syringe into the pen, dial up the units, press the plunger then check the reading on the syringe to make sure its the same as what you intended.
However I've noticed something really strange, whenever I do this for the first time it keeps underdosing yet whenever I do it for subsequent tries even as low as 2 units its dead on accurate.
This is what I did:
1. Insert cartridge into pen.
2. Add pen needle and keep dialling up the pen until the plunger is in contact with the cartridge stopper and some liquid comes out.
3. I then set it to 2 units, flicked it similar to a Mounjaro pen to ensure there's no air bubbled and pressed the plunger and the 2 units shot out so we can assume everything is accurately setup now and it should be ready for a dose?
4. Remove pen needle and insert insulin syringe.
5. Dial to any number of units 20, 60, 80, hold syringe and pen steady and press plunger. It underdoses
6. Remove insulin syringe, squirt out liquid, put it back in the pen and try the 20 units again. Dead on accurate.
7. Get rid of liquid try 2 units, 5 units, 10 units, 20 units etc. All dead on accurate.
It's as if the first dose you would take is always going to be inaccurate and this has been the same on all 4 pens I've tested and I don't understand why as I've taken all the correct steps to begin with to eliminate air and ensure the plunger is in proper contact with the cartridge stopper.
So I got some V1 pens and I decided to test the accuracy where you stick an insulin syringe into the pen, dial up the units, press the plunger then check the reading on the syringe to make sure its the same as what you intended.
However I've noticed something really strange, whenever I do this for the first time it keeps underdosing yet whenever I do it for subsequent tries even as low as 2 units its dead on accurate.
This is what I did:
1. Insert cartridge into pen.
2. Add pen needle and keep dialling up the pen until the plunger is in contact with the cartridge stopper and some liquid comes out.
3. I then set it to 2 units, flicked it similar to a Mounjaro pen to ensure there's no air bubbled and pressed the plunger and the 2 units shot out so we can assume everything is accurately setup now and it should be ready for a dose?
4. Remove pen needle and insert insulin syringe.
5. Dial to any number of units 20, 60, 80, hold syringe and pen steady and press plunger. It underdoses
6. Remove insulin syringe, squirt out liquid, put it back in the pen and try the 20 units again. Dead on accurate.
7. Get rid of liquid try 2 units, 5 units, 10 units, 20 units etc. All dead on accurate.
It's as if the first dose you would take is always going to be inaccurate and this has been the same on all 4 pens I've tested and I don't understand why as I've taken all the correct steps to begin with to eliminate air and ensure the plunger is in proper contact with the cartridge stopper.
Last edited: