Heavy overfill

[ForeverDieting]

I was browsing vendors for gkh-cu, I'm not sure if I was allowed to leave manufacturer, so I played it safe.

This is almost a 50 percent overfill that they posted themselves with on product page. Are they proud of that? Is that encouraged for such a peptide?

Being gkh-cu, is this not as big of a deal? If this was Retatrutide or something I would imagine it would be very worrisome for dosing.

 

[cheaperseeker]

It would be preferable to have accurate fills, but a lot of vendors treat overfills as a bonus, because you're getting extra. You can use the COA to adjust your dose accordingly.

 

[Chili777]

I would definitely readjust my dose based on that. It's a spicy shot at normal concentrations. It's only a bonus if you know beforehand.

 

[FNG33]

A very popular vendor here has COA's that show overfill on a lot of their products. 3 that i've seen, 3P test showing something much different.
Look for or get another test to confirm.

 

[Chili777]

A very popular vendor here has COA's that show overfill on a lot of their products. 3 that i've seen, 3P test showing something much different.
Look for or get another test to confirm.

My first kit was from Nexaph. The R48 was actually 58 mg. That's a lot. Most vendors are +/- 10% which is more understandable.

 

[Waclive]

I find it to definitely be a perk when you're aware of it. But also find it worrisome that most of them are a bit off, especially a GLP since the OD sides are very bad and dangerous.

I like that some vendors will print labels with the MG that it's tested at along with a QR to scan that will take you to the CoA. Yeah, it can be an elaborate misdirection. But to me, it would cost more to set all that up than to pay for a damn test. Especially with profits they're making.

But I am also someone who has been wrong before.

 

[FNG33]

The one's I've seen end up not being overfills or the suggested blend ratio.

 

[Nextlevel]

Yeah, an overfill of a few mg probably not a big deal but if the overfills are 30% to 50% more, I find that to be a problem. On the flip side, I probably wouldn't pay out of my pocket to find the correct fills on my supplies due to high cost.