GLP-1 Forum

KLOW Recon Efficiency and Storage

randompersonrandom

GLP-1 Enthusiast
Member Since
Aug 9, 2025
Posts
177
Likes Received
586
From
Texas
Ok, so I have a sort of workflow to do here that I would NOT have to do if I had been smart and bought KLOW components, then reconned myself. But I didn't, and here I am. Would welcome any insight, because I've read all over and am not sure what to trust.

I have a KLOW vial with:

GHK-Cu: 53.89 mg
KPV: 9.40 mg
BPC-157: 8.37 mg
TB-4: 8.89 mg

It hurts like a bugger, and I want my 5-1-1-1 ratio cause I've convinced myself that'll make it hurt less. So now I have one each as well of:
KPV 13.4mg
BPC 157 11.15mg
TB4 11.4mg

I recon the KPV, BPC, and TB4 to 10 mg/ml each. Then, into the KLOW vial goes
KPV: 1.378 mg 14 units
BPC-157: 2.408 mg 24 units
TB-4: 1.888 mg 19 units

Then into the KLOW vial, 3.43 ml of bac water, ends up being 4ml bac water total. 2ml each gets filtered into two sterile carts, and we're good to go for my thirty days.

Ok, here's where my questions start;

Can I freeze one sterile cart while I use the other one, for a single freeze-thaw? I don't actually know if KLOW freezes well, or if sterile carts do unpleasant things when you freeze them, or what precautions I should take when freezing a sterile cart; leave air in, leave NO air in, pray over it loud, etc.
What do I do with the remainder of the non-copper vials? I know I can't just stick them in the fridge, because I'm pretty sure they'll degrade by the time my thirty-day cycle is over and it's time to make another one. I'm certain it's not a good idea to freeze-thaw them up to eight or nine times. But I really don't want to waste a whole vial for 20-30ish units; because if I can keep them good, the half kit each I have of the non-copper will work to adjust all thirty vials I have, or at least come close, and I'm done playing around shopping.

Can I draw the right amount from each of the non-copper peptides for 1 klow recon into a syringe, cap it, put it in a thermos, freeze it, and just be able to pull and thaw them as needed?
 
Last edited:
If you are confident in your sterility, leave it in fridge. These things are pretty tough, should be fine. Don’t dig too deep into the degradation if it’s just sitting in fridge for a month or three. Check for cloudiness before using again if you are concerned.

You did the work up front with filtering and all.
 
If you are confident in your sterility, leave it in fridge. These things are pretty tough, should be fine. Don’t dig too deep into the degradation if it’s just sitting in fridge for a month or three. Check for cloudiness before using again if you are concerned.

You did the work up front with filtering and all.
The sterility isn't so much what spooks me, as that it definitely wouldn't be just a month or three for the non-coppers. for all of those, I have at least four recon "doses" in each vial; to use all of those up, it'd be one, two (first two months) then one month off, then three, four (second two months). That means they'd be in the fridge for as long as five months by the time I used the last of them. If it were tirz, I wouldn't worry, but I think those three aren't as tough as tirz.
 
Don't freeze. Keep refrigerated.
I have no problem using peps that have been reconstituted for 2 months as long as sterile techniques are used.
As for the stinging, I just mixed up a new batch as follows:
85mg GHK-CU
10mg TB-500
20mg BPC-157
10mg KPV
8.5 mL bac
.5 mL Lignocaine.
I use it till it's gone, way over a month.

Can't feel a thing using 21 units.
 
Don't freeze. Keep refrigerated.
I have no problem using peps that have been reconstituted for 2 months as long as sterile techniques are used.
As for the stinging, I just mixed up a new batch as follows:
85mg GHK-CU
10mg TB-500
20mg BPC-157
10mg KPV
8.5 mL bac
.5 mL Lignocaine.
I use it till it's gone, way over a month.

Can't feel a thing using 21 units.
You know, I've never even felt a sting; just a mean soreness twelve hours later, and a bruise. I've managed to cut both down by doing my shot and IMMEDIATELY taking a brisk walk, 2 miles or more, but I'm still working on it.

I'm watching a conversation in one of the discords about possible degredation of the individual components, and it's enough to have me a little spooked.
 

Trending Topics

Latest Posts

Forum Statistics

Threads
5,494
Posts
71,988
Members
15,671
Newest
LYLACS
Top Bottom