SS-31 and Mots-C Recon

[Whiynot20026]

I have a SS-31 50mg vial. Looks like 3ML recon suggested. I have a Mots-C 20MG vial looks like 2ML suggested. Can anyone that uses these validate these recons.

Thank you,
Bill

 

[CNCCurrency]

I have a SS-31 50mg vial. Looks like 3ML recon suggested. I have a Mots-C 20MG vial looks like 2ML suggested. Can anyone that uses these validate these recons.

Thank you,
Bill

https://peptidedosages.com/single-peptide-dosages/mots-c-20-mg-vial-dosage-protocol/

 

[CNCCurrency]

I have a SS-31 50mg vial. Looks like 3ML recon suggested. I have a Mots-C 20MG vial looks like 2ML suggested. Can anyone that uses these validate these recons.

Thank you,
Bill

https://peptidedosages.com/single-peptide-dosages/ss-31-50-mg-vial-dosage-protocol/

 

[Whiynot20026]

I can find the dosing sites. Just curious what users were doing? Thanks for the links. M

Bill

 

[CNCCurrency]

I can find the dosing sites. Just curious what users were doing? Thanks for the links. M

Bill

Pretty sure most follow these doses.

 

[Whiynot20026]

Pretty sure most follow these doses.

Thanks. I just wanted to double check in fear of not enough BAC for stinging. By the way. Caroline is super adorable.

Bill

 

[bluewater]

Those suggested recons are fine. I use the following with no issues recon and no issues with stinging (although not sure if that is a thing with SS31 or MOTSC)"

• 2.5ml BAC into SS31 50mg as it makes the maths easier.
• 2ml BAC into MOTS-C 20mg.

 

[eidos]

I have a SS-31 50mg vial. Looks like 3ML recon suggested. I have a Mots-C 20MG vial looks like 2ML suggested. Can anyone that uses these validate these recons.

Thank you,
Bill

Hi Bill

For SS-31, I make 10 doses of 5 mg from the 50 mg. So the pen lasts 10 days. I’ve switched to 2 ml of 0.9% NaCl (no BA). That makes small volumes of 0.20 ml. No more reactions at the injection site.

I haven't started the MOTS-c again yet. Since the last cycle ended with a huge hard lump on my thigh, I decided to change my strategy.

No more hypotonic BA, I'm switching to 0.9% NaCl. The vial doesn't last long enough for this to be a problem from a bacteriological standpoint. I'll use a pen with a 32G 4mm needle. No more syringes with 8mm at 45°. No more injections in the thighs.

I'll reduce the dose from 5 to 2.5mg.
I have 40 mg vials, which is 16 doses. I'm going to divide them into two cartridges: 8 x 0.30 ml in each, which is 2.4 ml of 0.9% NaCl each. (2.4 in the vial, split in 2x1.2 in cartridges, add 1.2 in each cartridge).

Hypotonicity adds a known problem to the injection. MOTSc adds a possible problem of an allergic reaction, which I hope to mitigate by diluting further and preventing aggregations through higher salinity. Since NaCl brings the pH closer to 7, I'm counting on that as well.

I don't know if you can see it, but I'm enjoying myself. It takes me back to when I was 20 and playing around with cytokines, IgG, HPLC, etc. and radioactive iodine (I can do without that one).