WBS Tesamorelin Gelling Problem

[RocketGotRobbed]

Until recently, I was using US based resellers like Atomik Labz. Recently, I ordered Tesamorelin 10mg from Jinjier @ WBS. Order arrived quickly and in good condition. Vials were inspected and immediately placed in freezer at 0F. Went to reconstitute a vial last night with a fresh bottle of Hospira BAC. I used 2mL like I have always used previously. Within minutes the vial was a lump of gel. No liquid was left. I have only ever had this issue with AOD9604 before. So, i naturally assume something must Brute Enforcer Emeritus wrong with the peeptide. Shouldn't be the water. But maybe it is. So I get another freshh bottle of Hospira BAC and a new vial of WBS Tesamorelin 10mg and try again. And sure enough, within minutes, it is gel.

So, I reach out to Jinjier @WBS and include pictures and her response was "What did you not use AA?"

Does anyone else here use Acetic Acid for Tesamorelin? I have never. Does anyone else here have any recent WBS Tesamorelin they want to test and see what happens?

 

[Calm Logic]

I don't know, but I would test the pH of the gel, if you still have it.

Maybe WBS is right about pH being a factor:

Only time I get precipitation is when the pH isn't appropriate for the peptide, like cagri and IPA a especially sensitive

OTOH:

I was told by the vendor not to adjust the pH it may cause it to gel.

As others have said, I mix my tesa with 2ml or bac water to 6mg and experience no sting at all. I've been driving tesa for four months.